| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| I’m a nervous wreck! http://www-.luthiersforum.com/forum/viewtopic.php?f=10102&t=3223 |
Page 1 of 1 |
| Author: | old man [ Wed Sep 14, 2005 1:27 pm ] |
| Post subject: | |
This was scary, to me anyway. All I needed was to install my end graft and the side assembly would be finished, ready for top and back. When I got ready to route a groove I couldn't find a bit the right size that would chuck into my dremel or my laminate trimmer so I used my 3 hp Bosch plunge router. I don't recommend everyone try this, although it came out fine, it sure made me nervous. I have since ordered the correct bit. Kinda like using a sledge hammer to drive a thumb tack. Ron 
|
|
| Author: | Josh H [ Wed Sep 14, 2005 1:30 pm ] |
| Post subject: | |
Hey, if it works. Josh |
|
| Author: | tippie53 [ Wed Sep 14, 2005 2:21 pm ] |
| Post subject: | |
I use a sharp utility knife and chisel. We all have out quirks john |
|
| Author: | Dave Rector [ Wed Sep 14, 2005 11:42 pm ] |
| Post subject: | |
I use a thin kerf Japanese saw to cut the channel and a good sharp chisel to remove the waste. Works ok, but I think I am going to switch to the router method as soon as I get a jig built. |
|
| Author: | Robbie O'Brien [ Thu Sep 15, 2005 1:27 am ] |
| Post subject: | |
a dovetail saw and then chisel out the area. This can be done in about ten minutes.  |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|